宝塔服务器面板,一键全能部署及管理,送你10850元礼包,点我领取

路由器变砖 可用usb转ttl 救急。刷机

操作方法

  • 01

    使用网线,连接电脑和路由器的wan口

    无线路由救砖 ttl刷机教程-风君雪科技博客

  • 02

    把usb转TTL线连接到电脑USB端口,另一端连接到路由器的TTL接口。接线方法 接线 路由器上VCC  不接 路由器 Tx   —  TTL线的RX针 路由器 Rx   —  TTL线的TX针 路由器GND   — TTL线的GND针

    无线路由救砖 ttl刷机教程-风君雪科技博客

  • 03

    安装usb转ttl 串口驱动。 在设备管理里面,要看到COM3出现; 把电脑网口IP配置为192.168.1.100; 安装TFTP   配置TFTP软件,刷机文件要放在TFTP指定目录下。

    无线路由救砖 ttl刷机教程-风君雪科技博客无线路由救砖 ttl刷机教程-风君雪科技博客无线路由救砖 ttl刷机教程-风君雪科技博客

  • 04

    配置串口终端。运行putty,点Serial,串口设置: 波特率 57600,NONE,8,1,NONE。 打开串口,开始显示路由器开机过程。

    无线路由救砖 ttl刷机教程-风君雪科技博客无线路由救砖 ttl刷机教程-风君雪科技博客无线路由救砖 ttl刷机教程-风君雪科技博客

  • 05

    路由器通电;U-Boot 1.1.3  config usb.. 10、在出现”config usb..”文字时,按“2”;******************************Software System Reset Occurred ****************************** __________________________________________________________________ |    ______        ___    ____   ___  _ _                        | |   / ___\ \      / / \  |___ \ / _ \/ / |  ___ ___  _ __ ___    | |  | |  _ \ \ /\ / / _ \   __) | | | | | | / __/ _ \| ‘_ ` _ \   | |  | |_| | \ V  V / ___ \ / __/| |_| | | || (_| (_) | | | | | |  | |   \____|  \_/\_/_/   \_\_____|\___/|_|_(_)___\___/|_| |_| |_|  | |                                                                | |                  Global Wireless Alliance                      | |                   http://www.gwa2011.com                       | |                  E-Mail:2579131212@qq.com                      | |                     Dreambox Team 2012                         | |________________________________________________________________| Please choose the operation: 1: Load system code to SDRAM via TFTP. 2: Load system code then write to Flash via TFTP. 3: Boot system code via Flash (default). 4: Entr boot command line interface. 7: Load Boot Loader code then write to Flash via Serial. 9: Load Boot Loader code then write to Flash via TFTP. You choosed 2 0 eth_register Eth0 (10/100-M) enetvar=ethaddr,Eth addr:00:0C:43:09:26:BB eth_current->name = Eth0 (10/100-M) 2: System Load Linux Kernel then write to Flash via TFTP. Warning!! Erase Linux in Flash then burn new one. Are you sure?(Y/N) 输入“Y”, 并按照下面输入相应信息:Please Input new ones /or Ctrl-C to discard         Input device IP (192.168.1.1) ==:192.168.1.1         Input server IP (192.168.1.100) ==:192.168.1.100 Input Linux Kernel filename () ==:0223.bin输入回车,刷机开始开始刷机。正确TFTP传输文件时,电脑TFTP上面会显示如下信息,表明TFTP开始传输文件 。 TFTP文件传输完毕。路由器删除FLASH,并将固件写入FLASH。

    无线路由救砖 ttl刷机教程-风君雪科技博客

  • 06

    刷机完成后,路由器会重启,重启完毕,在TTL串口putty里面,输入回车,会显示如下信息,表明刷机已经成功:BusyBox v1.15.3 (2013-02-23 13:25:51 CST) built-in shell (ash) Enter ‘help’ for a list of built-in commands.   ______        ___    ____   ___  _ _ / ___\ \      / / \  |___ \ / _ \/ / |  ___ ___  _ __ ___ | |  _ \ \ /\ / / _ \   __) | | | | | | / __/ _ \| ‘_ ` _ \ | |_| | \ V  V / ___ \ / __/| |_| | | || (_| (_) | | | | | | \____|  \_/\_/_/   \_\_____|\___/|_|_(_)___\___/|_| |_| |_| ——Dreambox-GWA(2013, r570) ————   * 全球无线联盟 哦耶  * Global Wireless Alliance, AE   * http://www.gwa2011.com   * Mail:2579131212@qq.com   * Powered by Openwrt-Dreambox 2013 ————————————————root@AE:/#